A different look at your PCB – Infrared

Here are some pictures of the same PCB, but running different software applications:

  • Notice the CPU temperature difference when nothing is running (49.9°C) and when a test is running (76.4) – compare the first and third picture.
  • Have a look at the picture in the middle. Memories become more visible when running a memory test.
  • See the huge difference in Ethernet temperature when Ethernet cable is connected (the middle picture, bottom right corner) and disconnected.
  • It’s interesting to see, how the whole PCB will warm up from a few hot components – the module PCB is much warmer than the Baseboard PCB (in background).
Uboot only (Ethernet unplugged)
Memory test (Ethernet connected)
CPU test + Memory test (Ethernet unplugged)

If you use a hot air gun, how the heat will spread on PCB?

This was also an interesting experiment, we used a hot air gun (you can see it on the right picture) to heat up a small PCB. Notice, how the middle GND exposed pad is much colder then the area without copper (note: the result may be affected by the shiny surface of golden areas).

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s